• Cooltec - RFA16 2.4GHz FASST compatible 16 channel receiver plastic case changeable double antenna
  • Cooltec - RFA16 2.4GHz FASST compatible 16 channel receiver plastic case changeable double antenna
1/1

Cooltec - RFA16 2.4GHz FASST compatible 16 channel receiver plastic case changeable double antenna

No.
SKU:
Login or Register to see prices
Received successfully
Coupon Code
CONTINUE SHOPPING
  • Cooltec - RFA16 2.4GHz FASST compatible 16 channel receiver plastic case changeable double antenna
  • Description

SPECIFICATIONS:
Operating Voltage Range : 3.5~8.4V
Dimension:46.7X14.6X36.8mm
Weight:12.5g
Latency:14ms(LS):7ms(HS)
Sensitivity: about -96dBm

INTRODUCTION:
Cooltec 2.4GHz Spread Spectrum FASST Compatible Receiver is designed to use with FUTABA FASST 2.4GHz Air System(7CH Mode/Multi Mode), such as TM7, TM8, TM10, TM14 or T6EX-2.4G, 7C-2.4G, 8FG, 10CG, 12FG , 14MZ, 14SG, 18MZ.

BINDING PROCEDURE:
Turn on the transmitter, get to the LINKAGE MENU - SYSTEM and select FASST-7CH or FASST- MULT, Connect
battery to the receiver while holding the F/S button on the receiver, the red LED on the receiver is off and green LED constant on indicates binding successfully.


SETTING FAILSAFA:
RFA16 support two delectable failsafe setting options, either use native failsafe position preset on transmitter, or set failsafe on RFA16.
1) Use native failsafe position preset on the transmitter side:
If not disabling failsafe on the transmitter side, RFA16 will use native failsafe position preset on the transmitter side.
2) Set failsafe on RFA16:
RFA16 supports failsafe function for all channels. Follow the steps below to set failsafe positions for each channel.
(1) Bind the receiver first and disable failsafe on the transmitter side;
(2) Set all transmitter controls to the desired failsafe position;
(3) Press briefly the F/S button on the receiver(less than 1 second), the green LED will flash twice, indicating the failsafe is set up successfully;
(4) To disable the failsafe function, just need to rebind the receiver.

HOW TO SWITCH BETWEEN LS AND HS MODES:
Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6 seconds and then release. The red LED will flash fast in HS mode and slow in LS mode. Repeat this to alternate modes.


Frequently Bought Together
more
Frequently Bought Together