Happymodel Sailfly-X 2-3S Micro brushless FPV racer drone
No.
HP037-0143
| Item Name | Qty |
| Sailfly-X frame | 1 |
| 30 degree angle canopy(red 3d print tpu) | 1 |
| 40 degree angle canopy(purple 3d print tpu) | 1 |
| Option1: Crazybee F4FR V2.1 PRO FC built-in Frsky RX | 1 |
| Option2: Crazybee F4FS V2.1 PRO FC built-in Flysky RX | |
| Option3: Crazybee F4DX PRO V2.1 FC built-in Serial-bus DSM2/DSMX RX | |
| Option4: Crazybee F4 V2.1 PRO FC no RX verion | |
| EX1102 KV9000 Motor | 4 |
| 65mm propeller(6cw+6ccw) | 1 |
| HCF7P 25mw VTX/700tvl camera AIO | 1 |
| 3S 11.4v 300mah 30C/60C battery | 1 |
| Propeller disassemble tool | 1 |
| Screwdriver | 1 |
| Motor | Mode: EX1102 KV9000 Configu-ration:9N12P Stator Diamter:11mm Stator Length:2mm Shaft Diameter:Φ1mm Motor Dimension(Dia.*Len):Φ13.5mm*16mm Weight(g):2.8g No.of Cells(Lipo):2S-3S |
| Flight controller | (Frsky version) CRAZYBEE F4FR PRO V2.1 Firmware target: CrazybeeF4FR (Flysky version) CRAZYBEE F4FS PRO V2.1 Firmware target: CrazybeeF4FS (DSM2/DSMX version) CRAZYBEE F4DX PRO V2.1 Firmware target: CrazybeeF4DX (No RX version) CRAZYBEE F4 PRO V2.1 Firmware target: CrazybeeF4DX MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 2-3S battery input (DC 7.4-13V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Frsky version Built-in SPI Frsky receiver with telemetry(D8/D16 switchable) Flysky version Built-in SPI Flysky receiver with telemetry(AFHDS/AFHDS2A switchable) DSM2/X Version built-in Serial-based DSM2/DSMX compatible satellite receiver No RX version need to add external Receiver Built-in Betaflight OSD(SPI Control) Built-in Current meter Max 28A Current meter scale set to 1175 Built-in 5V 1A BEC with LC filter Built-in voltage detection |
| Onboard 4in1 ESC | MCU upgraded to EFM8BB21 Power supply: 2-3S LiPo/LiPo HV (7.4v/13v) Current: 5A continuous peak 6A (5 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7.Hex Default protocol: DSHOT600 |
| Frsky receiver Version | SPI BUS receiver Frsky D8/D16 switchable Compatible both Non EU and EU-LBT transmitter Channels: 8ch or 16ch EU-LBT support(need to update betaflght v4.0 date 2019-04-11) Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 300m |
| Flysky receiver Version | SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 300m Failsafe support |
| DSM2/DSMX receiver version | Serial bus receiver Protocol: DSM2/DSMX compatible Channels:6-9 (Depend on your radio) No ground interference ( Transmitter and receiver 1 m from the ground): 300m |
| PNP No RX version | No RX version support external serial-bus receiver like xm+, crossfire, S-FHSS etc. |
| AIO Camera&VTX (HCF7P) |
Output power: 25mw Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Camera resolution: 700TVL Field of view: 120° Video Format: NTSC Antenna: RG178 antenna Frequency: 5.8GHz 5bands 40 channels With Raceband Smartaudio ready(Frsky EU-LBT and DSMX version not compatible) Size: 13.9"12.0mm ( L*W ) Weight: 3.2g |
| Lipo Battery | Capacity:300mAh Voltage:11.4v Continuous Discharge Rate: 30C Instantaneous discharge rate: 60C Size: 65mmx18mmx11mm Weight: 25g Connector: XT30 |
